AENO RC2S Guia De Inicio Rapido página 12

Action
Press once
Wi-Fi button (12)
Press and hold
Preparing the device for operation (Fig. C, D)
1. Open the packaging and remove the device and accessories. Remove all
packing materials and plugs from the sides of the vacuum cleaner.
2. Attach the side brushes.
3. Place the charging base on a flat, stable, horizontal surface.
4. Plug the charging base in by plugging the power adapter connector into
the joint on the base and the plug into outlet.
5. Charge the battery by placing the vacuum cleaner on the charging base by
connecting the contacts on the vacuum cleaner to the contacts on the base.
If the vacuum cleaner is positioned correctly, the indicator on the base will
start flashing green and charging will begin. When charging is complete,
the indicator will light green continuously.
Note. The first charge takes up to 6.5 hours.
Control the vacuum cleaner with the buttons on the body
WARNING! Remove hazardous objects from the floor before operating the
cleaner (see "Restrictions and warnings"), power cables, valuables.
1. Dry cleaning. Press the "Start/Stop" button to start the cleaning. Pressing
the button again will pause cleaning.
2. Wet cleaning (Fig. E). Remove the dust container from the vacuum cleaner.
Pour purified water into the water tank to at least 2/3 of its volume and close
the valve tightly. Attach the fabric cover to the water tank. Insert the water
tank into the vacuum cleaner. Press the "Start/Stop" button to start the
cleaning. You can additionally control the water supply from the AENO
application.
Note. The vacuum cleaner automatically returns to the base to charge after cleaning
is complete and when the battery is low. After charging, the cleaner resumes cleaning
from where it was interrupted.
12
Description
Starting or stopping cleaning
Switching to pairing mode
aeno.com/documents