Publicidad
Idiomas disponibles
Idiomas disponibles
3. RE-ATTACH THE COLD
COMPARTMENT SHOW CASE DOOR
To re-attach the COLD COMPARTMENT SHOW
CASE DOOR, assemble the parts in reverse order.
4. RE-ATTACH THE HINGE COVER
1. Open the refrigerator doors.
2. Attach the hinge cover to the top of the
refrigerator.
Secure the cover in place with the three screws
you removed earlier using a Phillips screwdriver.
5. RE-ATTACH THE WATER SUPPLY
LINER
1. The Water Line must be fully Inserted to the
center of the transparent coupler to prevent
water leakage from the dispenser.
2. Insert the 2 clips in the install pack and check
that each clip holds the line firmly.
CAUTION
Keep the clips out of the reach of children and
make sure that children do not play with them or
put them into their mouths.
DA68-02976A-10.indb 16
Center of Transparent coupler
Clip A (1/4")
(6.35 mm)
English - 16
LEVELING THE REFRIGERATOR
AND ADJUSTING THE HEIGHT
AND GAP OF THE DOORS
How to level the refrigerator
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
Setting up the refrigerator on an uneven surface
will cause the refrigerator to lean.
If the freezer side is lower:
• Insert a flathead screwdriver into the height
leveler located at the bottom back of the freezer
door and turn it in the direction of the arrow
until it is level.
If the refrigerator side is lower:
• Insert a flathead screwdriver into the height
leveler located at the bottom back of the
refrigerator door and turn in the direction of the
arrow until it is level.
2018. 7. 9.
5:13
Publicidad
