Phone Book Management; Superkeys; Remote Programming By Text Message; Output Management - Bentel Security BTEL-GT Manual De Instalación Y Usuario

for <Telephone Number>, type the number that you are calling (up to 16 digits).

Phone Book Management

ATTENTION - To exit from the Phone Book Management menu and go back, press the
Write Phone Book
To enter a telephone number, type the following keypad sequence:
where <Position no.> is a number from
 ?   C
example
The dialer can store up to 9 telephone numbers, each up to 16 digits long.
Read Phone Book
To check the programmed phone number, type the following keypad sequence:
where <Position no.> is a number from
number (position no. 3) displayed, type
Delete
To delete a programmed phone number, type the following keypad sequence:
where <Position no.> is a number from
telephone number (position no. 3), type

Superkeys

The BTEL-GT has two SUPERKEYS (the
seconds, perform specific actions:

— When you press , a call is made to the telephone number stored at position 9 in the phone book and
the speakerphone function is enabled. After 5 minutes and after that at 30-second intervals, a tone is sounded
on the audio channel. To end the call, press or wait for the other party to hang up.

— When you press , a call is made to the telephone number stored at position 9 in the phone book and voice
message no. 7 is played five times. If the call result is not successful (no answer, busy, or unreachable), the
device automatically attempts to call again 5 times (after 1, 2, 5, and 10 minutes). Repeated call attempts can
be ended by the Block Calls option (see the "Block Calls" section) or by activating Input no. 4 (L4).

The SUPERKEY
During calls made with Superkeys

Remote Programming by text message

By sending specific text messages, you can manage some features of the BTEL-GT. For the features, see
the paragraphs below.

Output Management

Open Collector outputs OC1, OC2, and OC3 can be set as Bistable (enabled and disabled with 2 different commands)
or as Monostable (the output is active for its ON Time, after which it returns to standby). Output OC4 is set as Bistable.
If the output is enabled by sending a text message, Confirm Output Activation Enable (if programmed
by the installer) will be sent by text message.
GSM Telephone dialler

<Telephone Number>
 ?
<Position no.> <Telephone Number>
 
to , while <Telephone number> is a number of up to 16 digits. For
(the telephone number entered in the phone book in position no. 1 is 3470).
 @
 
to . If, for example, you want the third programmed telephone
 @ 
 A
 
to . If, for example, if you want to delete the third programmed
 A 

key and the
function cannot be enabled if other calls are in progress.
 
and the other party can access the User Menu remotely by pressing
C
C
<Position no.>
.
<Position no.>
.

key), which, when pressed for at least 3
D
key.
G
.
21