Bentel Security BTEL-GT Manual De Instalación Y Usuario página 14

A <Voice message> will be sent only if all the messages in it are valid (i.e. not empty).
D
If the key is pressed (see the paragraph "Programming by Keypad") during programming,
the data entered will be disregarded and the previous data will be kept.
Management Repetitions of Voice Messages
To program the number of times that voice messages will be repeated, type the following keypad sequence:
where <Number of repetitions> corresponds to the number of repetitions requested (from
factory default setting for the number of repetitions is 1 (to send the voice message only once).
Management Call Cycles
When an alarm event takes place, the phone numbers in the phone book associated with the triggered input
are called (in the order that the phone numbers are saved in the phone book) and the programmed voice
messages are played. By programming call cycles, you can keep trying to call numbers that for some
reason have not answered their call (no answer, busy, or unreachable). If the call is successful, the dialer
will not call the subsequent numbers, unless the "Call All " option has been enabled. Program the number
of times a call is attempted for each programmed telephone number by entering the following formula:
where <Call Cycles> corresponds to the number of times the call cycle must be repeated (from
The factory default setting for call cycles is 1 (perform only one call cycle). The call cycles are enabled at
increasing intervals: after 1, 2, 5, 10, 15, 20, 25, and 30 minutes.
Input no. 1 (L1) takes priority over the other channels; if input no. 1 (L1) is activated, its call
cycle is performed, even if at that moment the call cycle of a different input was under way.
Management Call All
When an input is activated, a message is sent to all the telephone numbers linked with that input, continues
calls even if one of the numbers answered.To program this feature, type the following keypad sequence:
Management Call Confirm Result
If this option is enabled, the BTEL-GT considers only voice calls that were confirmed by the user to be
successful. If "Call Confirm Result": is enabled, the person answering will need to confirm receipt of the
call after receiving the voice message and before the dialer ends the call by pressing the
on their own telephone (DTMF). If neither the
successful and the programmed call cycle will be executed (see the section "Management Call Cycles").
To program this feature, type the following keypad sequence:
If the "Call Confirm Result" feature is enabled, pressing
pressing allows access to the voice menu.
In some cases the BTEL-GT may misinterpret the answer from answering machines, ringback
tones, GSM operator courtesy messages, etc. Users are advised to enable the "Call Confirm
Result" function.
14
? A @
<Number of repetitions>
? A A
<Call Cycles>
? A A
<Call Cycles>
? A B ?
(to Enable)
? A B A
(to Disable - factory default setting)
or the
? A C ?
(to Enable)
? A C A
(to Disable - factory default setting)
key is pressed, the call will not be considered
ends the call immediately, while
 
to ). The
 
to ).
or the key
BTEL-GT