Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
OPERATION GUIDANCE
Press the switch
2
level of NOMAD POWER
CHARGING INSTRUCTION
1. Plug the home adaptor into the universal socket
2. Connect the Type-C connector to the NOMAD POWER host
3.The indicator
1
paused or completed
USING AS JUMP START 12 V
1. Connect the jump start socket into the host
2. Connect red clamp to the positive (+) battery terminal, black clamp to the negative (-)
battery terminal.
3. Operate following the instruction of the cable indicator :
10
NOMAD POWER PRO 700
Indicator
to check the storage
will flash one by one during the period of charging. All indicators light off when the charging is
GREEN LIGHT On :
Telling the connection is correct and
the circuit is working, you can turn
on the engine to jump-start directly.
GREEN LIGHT blinking with
buzzing :
Saying the vehicle battery is low,
press the «BOOST» button, wait
GREEN LIGHT becomes solid, then
turn on the engine within 30s.
Storage
level
100%
75%
50%
25%
0%
7
8
, and make sure the Cable Indicator is off.
RED LIGHT On with buzzing :
Telling the connection is wrong,
and buzzing to alarm to correct the
clamps as step 2 mentioned above,
wait until the GREEN LIGHT is on to
turn on the engine.
No lights on, no buzzing :
Saying the vehicle's battery may-
be damaged, after confirmed the
clamps connection is correct, press
the «BOOST» button, wait GREEN
LIGHT is on, and then turn the en-
gine within 30s.
EN
Publicidad
