Rocket BOXER Manual De Uso Y Mantenimiento página 47

5.4 Hot water dose
programming
Unlike coffee dose programming, hot water
doses must be programmed for each unit by
acting on the relevant unit pushbutton panel.
Proceed as follows:
■ Hold the key
starts flashing.
■ Release the key and press the one to be
programmed (
water dispensing.
■ When the desired quantity of water is
reached, press the same key
stop dispensing.
■ Once the programming operations are
complete, switch the machine off and on
again after 5 seconds.
Note: The volume of hot water
i
dispensed is timed and, there-
fore, also depends on the pres-
sure in the boiler. There may
be differences in the quantities
actually dispensed.
MACHINE
UNDER
(1 - fig._5.1) until its LED
MAINTENANCE
6 - fig._5.2), starting
again to
BOXER
6
- MACHINE OPERATION
Make sure that the machine is
i
ready for full safety operation
as described in the previous
chapters
1. Install the portafilter by inserting it into the
group head and rotate the portafilter handle
from left to right. The portafilter is inserted
properly once it is firmly inside the group
head and the portafilter handle is sitting at
90 degrees from the face of the machine
(fig._6.1)
fig_6.1
2. One of the buttons (1-5 fig_6.2) can now
be pressed to let the water flow through the
filter holder.
fig_6.2
3. It is important to leave the portafilter in-
stalled in the group head when not in use.
The portafilter must remain heated for a
successful brew process. It will also prevent
the head seal inside the group head from
drying out prematurely.
EN
47