Publicidad
Idiomas disponibles
Idiomas disponibles
4
ASSEMBLING RTA SHELVING (IF APPLICABLE).
4A. CHOOSE INSTALLATION POSITION FOR VERTICAL DIVIDER (D): Determine the most convenient position for shelf installation – either
left or right. Install 4 cam screws (F) in the top left, top right, and two of the bottom pre-drilled holes. The two bottom holes you select will
determine the location of the central divider.
RIGHT SIDE SHELF CONFIGURATION
4B. INSTALL HORIZONTAL SUPPORT (BOTTOM PIECE)
Using a rubber mallet, carefully tap 4 cam locks (E) into component A and component D.
Align cam locks with the two upper cam screws on the left and right of the cabinet box. Push piece
in place, tighten the cams.
Take divider (D) and align with bottom installed screws (F) and tighten.
Then carefully push Component A to rotate it, creating a horizontal surface within the cabinet.
Ensure straight edge of cam lock is flush with edge of shelf (top).
Incorrect installation may lead to product damage.
4C. INSTALL ADJUSTABLE SHELF COMPONENT C
Take shelf pins (H) and push into two of the remaining pilot
holes on vertical divider (component D) and side of cabinet
box.
The shelf pins should be pushed in by hand or lightly tapped
with a rubber mallet.
A
C
Finished edge
faces out
Front of cabinet
D
Applies to PPCBYWHT24, PPCBYSBR24, & PPCBYSSR24
LEFT SIDE SHELF CONFIGURATION
A
Finished edge
faces out
F
4D. INSTALL VERTICAL SUPPORT (BACK PIECE) COMPONENT B
Using a rubber mallet, carefully tap cam locks (E) into component B.
Install final cam screws (G) into left and right cabinet side pre-drilled holes.
Secure component (B) to component (A) by installing wood screws through
the pilot holes in component (B).
G
E
E
A
Front of cabinet
Finished edge
faces out
E
D
F
B
E
E
Please contact 1-888-774-8062 for further assistance.
I
G
HOMEDEPOT.COM
Publicidad
