Publicidad
Idiomas disponibles
Idiomas disponibles
Mobile EV Charger EVSE User Manual
Operation
The Mobile EV Charger is very easy to use. Plug the EVSE into any grounded 120 V dedicated outlet, ensuring the receptacle
and plug have a snug fit. Unwrap the SAE J1772 charge cable and plug the charge coupler firmly into the vehicle's charge
port. Always plug the EVSE into the wall socket first.
Normally, the vehicle will immediately request a charge using a special communication line in the cable. Within a few
seconds, the charging cycle will begin, and the green 'Charging' light will turn on. The vehicle battery pack will require
several hours (length of time depends on the vehicle acceptance rate, battery pack size, and the vehicle's state of charge)
to fully recharge after an average driving day. Charging overnight is the most convenient way to maintain healthy batteries
and ensure the vehicle's full range will be available for the next day. It is also the time of day when power is typically the least
expensive to charge your car.
When the vehicle has stopped charging, the green "Charging" light on the Mobile EV Charger will turn off. When
disconnecting the EVSE, always remove the vehicle connector first, then remove the plug from the wall socket. Do Not
unplug from the wall while the vehicle is still connected.
To remove the charge coupler once a charge cycle has completed (or to interrupt a charge in progress), press and hold
down the latch release lever on the charge coupler handle, then unplug the charge coupler from the vehicle charge port.
When not in use, the cord should be neatly stowed away.
If charging always takes place in the same location, such as the home garage at night, the Mobile EV Charger may be left
plugged into the wall socket without damage.
If the EVSE will be moved often, it is highly recommended that a hospital-grade outlet is used as they are more robust.
February 2024
140-00265-04
© 2024 Enphase Energy Inc. All rights reserved.
9
Publicidad
