ProSelect PSTSP11AWH Guia Del Usuario página 4

Program schedule override (temporary)
1 Press or
temperature.
2 Once at the desired setpoint
temperature, no further action
is needed. The new setpoint
temperature will be held until
the next scheduled time period
begins. For more information on
schedule time periods, see "Program
Schedule" on page 3.
3 To cancel the Temporary Hold, Press
or and then press Cancel.
Program schedule override (permanent)
1 Press or
temperature.
2 Temporary Hold displayed and the
setpoint temperature flashes. While
it's flashing, press Hold (Mode) button
to change to Permanent Hold.
3 To cancel the Permanent Hold, press
and then press Cancel.
or
Adaptive Intelligent Recovery
Over time, the thermostat "learns" how long it takes your system to reach the
temperature you want. It turns on the heating or cooling system earlier to make
sure you're comfortable at the time you expect.
Built-in compressor protection
Damage can occur if the compressor is
restarted too soon after shutdown. This
feature forces the compressor to wait for a
few minutes before restarting.
During the wait time, the display will flash
the message Cool On (or Heat On if you
have a heat pump). When the safe wait time
has elapsed, the message stops flashing
and the compressor turns on.
to adjust the
to adjust the
Message flashes until safe
restart time has elapsed.
4
M39350
M39351
M39352