Publicidad
Idiomas disponibles
Idiomas disponibles
Viewing Battery Status
The Battery Status LED Indicators indicate the battery charge level
as follows:
• If the battery charge level is at full capacity, all three Battery
Status LED Indicators light.
• If the battery is at partial charged, two Battery Status LED
Indicators light.
• If the battery is nearly empty, only one Battery Status LED
Indicator lights. The unit should be charged at this time.
• If the battery is completely empty, only one Battery Status LED
Indicator flashes for a short period of time. The unit MUST be
charged at this time or the unit's built-in low voltage protection will
activate and the unit will automatically shut down.
CHARGING / RECHARGING
This unit is shipped in a partially charged state. Charge the unit after
purchase, before first use, and after each subsequent use until all
three blue Battery Status LED Indicators light.
IMPORTANT:
1. When the unit is not in use, we recommend that the battery is
charged at least every 3 to 6 months.
2. Recharging the battery after each use will prolong battery life;
frequent heavy discharges between recharges and/or overcharging
will reduce battery life.
3. Make sure all other unit functions are turned off during recharging,
as this can slow the recharging process.
NOTICE – TO AVOID THE RISK OF PROPERTY DAMAGE: Failure
to keep the battery charged will cause permanent damage and result
in poor performance.
NOTES:
During the charging process, the unit will stop charging if the battery
of the unit is overheated (due to extensive use or recharging) or too
cold (the ambient temperature has dropped below 0°C). If the battery
is overheated, the Battery Status LED Indicators light solid and the
Overheat Indicator lights solid as well. If the battery is too cold, the
Battery Status LED Indicators light solid and the Cold Indicator lights
solid as well. The charging process will automatically resume after a
cool down or warm up period.
CHARGING/RECHARGING USING THE 120 VOLT AC/USB
CHARGING ADAPTER
IMPORTANT:
• The unit can only be charged and recharged through the First
USB-C Port.
• Always connect the 120V AC/USB Charging Adapter to the 120
Volt AC power source (using the USB-C to USB-C Charging Cable)
BEFORE connecting it to the unit.
1. Make sure the unit is turned off (the Battery Status LED Indicators
are not lit).
2. Insert one USB-C plug of the USB-C to USB-C Charging Cable
into the 120V AC/USB Charging Adapter.
3. Insert the 120V AC/USB Charging Adapter into a standard 120
volt AC wall outlet or a functioning 120 volt AC power source.
4. Lift up the protective cover of the First USB-C Port (refer to the
"Features" section to locate). Insert the other USB-C Plug of the USB
Charging Cable into the unit's First USB-C Port.
5. When the unit is properly connected, the blue Battery Status LED
Indicators will gradually light up (from left to right) to indicate the unit
is charging.
6. Charge until all three blue Battery Status LED Indicators light.
7. Disconnect the USB Charging Cable from the 120V AC/USB
Charging Adapter and the unit.
10
Publicidad
