Publicidad
Idiomas disponibles
Idiomas disponibles
recommended when working outdoors. Wear protective hair covering
to contain long hair.
• Be extra careful to avoid dropping a metal tool onto the battery. It
might spark or short-circuit the battery or another electrical part and
could cause an explosion.
• Jump-start procedures should only be performed in a safe, dry,
well-ventilated area.
• Always store battery clamps when not in use. Never touch battery
clamps together.
• Make sure to connect the clamps with correct polarity.
• Do not expose battery to fire or intense heat since it may explode.
Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Place this unit as far away from the battery as cables permit.
• Never allow battery acid to come in contact with this unit.
• Do not operate this unit in a closed area or restrict ventilation in any
way.
• This system is designed to be used only on vehicles with a 12 volt DC
battery system. Do not connect to a 6 volt or 24 volt battery system.
• Excessive engine cranking can damage a vehicle's starter motor. If
the engine fails to start after the recommended number of attempts,
discontinue jump-start procedures and look for other problems that
may need to be corrected.
• Do not use this jump starter on a watercraft. It is not qualified for
marine applications.
INSTRUCTIONS PERTAINING TO THE 12V DC/USB
CHARGING ADAPTER
CAUTION: To avoid the risk of property damage:
• NEVER CONNECT THE UNIT TO A POSITIVE GROUNDED
VEHICLE.
• The 12V DC/USB Charging Adapter must only be connected
to batteries with a nominal output voltage of 12 volts. The unit
will not operate from a 6 volt battery and will sustain permanent
damage if connected to a 24 volt battery.
• Always connect the 12V DC/USB Charging Adapter to the 12
volt DC power source before plugging any devices into it.
INSTRUCTIONS PERTAINING TO THE USB PORTS
IMPORTANT: Some household USB-powered electronics will
not operate with the USB Ports provided with this unit and
its Charging Adapters. Check the manual of the corresponding
electronic devices (including phones, tablets, etc.) to confirm that they
can be used with one of these USB ports and which USB port to
use (Type A or Type C).
• The USB ports do not support data communication. They
only provide power to an external USB powered device, as follows:
– Do not use this unit to operate appliances that require more than
15W for the USB-A Port; up to PD 60W when using the First
USB-C Port; up to PD 25W when using the Second USB-C Port;
total 15W output on both the USB-A and the Second USB-C
when they are used simultaneously.
– PD 30W (5VDC 3A, 9VDC 3A, 12VDC 2.5A, 15VDC 2A, 20VDC
1.5A) using the USB port on the AC/USB Charging Adapters.
– PD 30W (5VDC 3A, 9VDC 3A, 12VDC 2.5A) using the USB port
on the DC/USB Charging Adapters.
– Make sure the rating of equipment plugged into the USB Port
does not exceed the maximum rating stated.
• Always connect the appropriate charging adapter to either the 120V
AC or 12V DC power source before plugging any devices into it.
7
Publicidad
