KitchenBrothers KB4024 Manual De Instrucciones página 28

• Be aware of the risks and consequences associated with improper use of the
product. Misuse of the product may result in personal injury and damage to the
product.
• Before first use, remove all packaging material and any stickers.
• The product is intended for domestic and commercial use such as; in staff
kitchens; in retail stores; in offices and other work environments; by customers
in hotels, motels and other residential environments; in bed & breakfast
environments; on farms.
• Keep the product away from heat, areas where temperatures are relatively high,
and heat sources such as furnaces.
• If the product is left unoccupied for a long time, turn it off, defrost, clean, dry and
leave the door open to prevent mold from growing inside the product.
• Do not store explosive substances such as aerosols containing flammable
propellant near or inside the product.
• Check that the refrigeration capacity of the product is suitable for storing the food
or medicine. Food should be stored only in its original packaging or in suitable
containers.
• There must be sufficient space to reach and fully open the door.
• Always use the product on a level surface and make sure there is free space
under and around the motor housing. Keep the vents at the bottom of the motor
housing free of dust and lint to prevent fire, never expose them to liquids or
flammable materials such as newspapers, napkins, tea towels, etc.
• The refrigerant isobutane (R-600) is in the product's refrigeration circuit. This is a
natural gas with a high degree of environmental compatibility, yet is flammable.
• The product should not be placed near radiators or stoves.
• Keep the product away from open flames, lit cigarettes and other heat sources
and/or hot surfaces.
• Keep the product away from sharp and pointed objects that may damage the
material.
• Always keep the product upright while transporting it. Transporting the product
should always be done without tilting or laying on its side.
• After unpacking and before turning on, the product should be placed on a flat
surface for more than 4 hours. This will allow the cooling circuit oil to return to its
intended location in the circuit.
• Place the product on a dry, level surface. This product is intended for workbench
applications.
• Place the product at least 1 meter away from flammable substances, such as
textiles, plastics, electrical appliances, wood, etc.
• Do not clean the product with sharp objects to remove frost from the product.
Use a plastic scraper for this purpose.
• Do not expose the product to direct sunlight, extreme temperatures, humidity or
wet environments for an extended period of time.
• Avoid open flames and ignition sources. This may cause personal injury and
damage to the product.
28