Casselin 700 Serie Manual Del Usuario página 19

are found in a bag supplied with the gas cooker and are marked in hundredths of a mm (table of technical
characteristics of the pipes).
Replacing nozzles and adjusting pressure
To replace the main burner nozzle, proceed as follows:
1) remove the control buttons from the front panel (fi g.1, note 1)
2) remove the front panel (fi g.1, note 2)
3) we recommend that you also dismantle the rear panel (if possible) for easier access (fig.1, note 3)
4) Adjust the air inlet for the relevant gas according to the "TECHNICAL DATA" table.
Important :
After setting the appliance to another type of gas, it is necessary to change the gas indicated on the technical
plate located in a visible place on the back of the appliance.
"SAVING" reduced output flame adjustment
The "SAVING" reduced output flame can be adjusted using a screw placed in the valve body (note 1, fig. 5),
next to the valve shaft.
To adjust, proceed as follows:
- Remove the control button (note 1, fig. 4) by pulling it towards you.
- Adjust the diameter of the hole using a flat screwdriver.
HOLE FOR
FLAME
ADJUSTMENT
EN