LaserLiner StarFinder Plus Manual Del Usuario página 14

Manual calibration
Pressing the CAL button (5) manually calibrates
the device. This allows measurements to be
restarted and objects to be isolated more
precisely.
Maximum sensitivity is achieved when the
device is held in the air while calibrating. This
can be useful for AC-SCAN measurements.
The device and the wall must maintain contact during
!
calibration in STUD-SCAN mode and throughout the
entire measurement process. A hand should remain
at the device the entire time as well.
5
Select measurement mode
Briefly press the Mode button (4).
AC-SCAN: Locating live lines directly under
non-metallic cladding.
STUD-SCAN: Detecting wooden wall beams
and joists as well as metal in drywall structures
under non-metallic cladding.
6
Measuring in STUD-SCAN mode
Detecting wooden wall beams and joists as well as metal in
drywall structures, e.g. under gypsum fibreboard, wood panels
or other non-metallic cladding.
– Select STUD-SCAN (button 4)
– ON WALL: Place the tool against the wall
– PRESS CAL: Press the calibration button (5)
and wait until calibration is completed:
CAL OK
– MOVE: Move the tool slowly
across the surface.
14
EN