MPM MZE-25 Manual De Instrucciones página 22

EN
ing the part of the product that will be invisible when worn or used. We start from the lowest
temperature gradually increasing it . Silk, wool and man-made fabrics - to prevent the formation
of shiny stains, iron fabrics on the left side covering them with another thin fabric. Do not use
the sprayer function to prevent the formation of stains when ironing. Iron velvet and similar
materials in one direction, do not hold them in one place. Iron synthetic fabrics and silk on the
left side without using steam.
CAUTION! Always start ironing with the products requiring the lowest ironing temperature.
3. When the iron reaches the desired temperature the indicator light (7) goes out, wait a moment and
you can start ironing.
STEAM IRONING
1. Check whether there is an appropriate amount of water in the tank (8).
2. Set the recommended temperature (see: "TEMPERATURE SETTING" ).
3. Select the appropriate steam setting
CAUTION! Steam ironing is possible only at higher ironing temperature (temperature settings
from •• to ••• ) .
CAUTION! As the iron reaches the selected temperature, it will start to produce steam. The
device produces steam at a very high temperature!
IRONING WITHOUT STEAM
1. Set the steam controller in (1) the "NO STEAM" position
2. Set the recommended ironing temperature (see: "TEMPERATURE SETTING" ).
SPRAYER FUNCTION
This function may be used in order to remove the stubborn creases.
1. Check whether there is a sufficient amount of water in the tank (8).
2. In order to moisten the fabric that is to be ironed, press the sprayer button (3) several
times.
HIGH STEAM IMPACT FUNCTION
This function (4) may be used in the vertical and horizontal position. It is useful for remov-
ing creases on the hanging clothes, curtains, etc.
CAUTION! The iron shoots a lot of hot steam! Risk of scalding! Do not direct the vapor stream
at people or animals!
ANTI DRIP SYSTEM
The iron is equipped with the anti-drip system: the iron will automatically stop producing
steam when the temperature is too low.
AFTER FINISHING IRONING
1. Set the temperature knob to the minimum position.
2. Unplug the power cord (6) from the electrical socket.
3. After ironing with the use of steam, empty the water tank (8).
4. Put the iron in a safe place in an upright position and wait for it to cool down.
22
using the control slider (1).
.