Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
CAUTION! Never submerge the iron in water or rinse it under running water.
1. Wipe off limescale and other deposits from the iron's soleplate (9) with a damp cloth and
a (liquid) non-abrasive cleaner.
CAUTION! To keep the surface of the soleplate unscratched, the iron should not be placed near
any metal objects. Do not use scourers, vinegar or other chemicals to clean the soleplate.
2. Wipe the upper part of the iron with a damp cloth.
3. Regularly rinse the tank with water (8) and empty it after rinsing.
SELF CLEAN FUNCTION – SELF-CLEANING
Use this function once in two weeks. Especially if you use tap water instead of distilled
water. If the water in the area is very hard (i.e. limescale falls off the iron's soleplate during
ironing), the function should be used more frequently.
1. Make sure that the device is not connected to power sources.
2. Set the steam slider in (1) the "NO STEAM" position
3. Fill the tank to the MAX level.
4. Insert the plug to the earthed electric socket.
5. Select the maximum ironing temperature.
6. When the indicator lamp goes off, disconnect the iron from power sources.
7. Holding the iron over the sink, move the slider towards SELF CLEAN (2), then gently
shake the iron. Steam and hot water will start to escape from the iron's soleplate. Impu-
rities and limescale deposits will be flushed out.
8. After emptying the tank of water, release the SELF CLEAN slider (2). This activity must
be repeated, if there are lots of impurities in the iron.
ANTI CALC FUNCTION – ACTIVE ANTI-SCALE SYSTEM
The anti-scale cartridge prevents the steam outlet holes from being clogged by limescale.
It is permanently active and needs no replacement.
Do not use limescale removal agents as this may destroy the anti-scale cartridge.
STORAGE
1. Set the steam controller in the "NO STEAM" position
mains socket.
2. Empty the water tank (8).
3. Wait until the iron cools off. Wind the mains cable around the iron.
4. Always store the empty iron in an upright position on a stable surface.
.
and remove the plug from the
EN
23
Publicidad
