Descargar Imprimir esta página

Hisense AHP0822CW1W Instrucciones De Instalacion Y Uso página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Operating your portable air conditioner properly helps you to obtain the best possible results. This section explains proper air conditioner
operation.
□ Do not stay in direct air ow from the air conditioner for extended periods of time.
□ Never use in tightly enclosed spaces. Always ensure there is suf cient air ow
of outside air entering the household especially when used in conjunction with
combustible devices such as gas stoves, replaces, furnaces, hot water heaters
etc. Do not place the power cord or air conditioner near a heater, radiator, stoves
or other apparatus (including ampli ers) that produce heat.
□ This air conditioner is intended for household use as a residential appliance.
Do not use it as a precision climate control for commercial use, or for precision
equipment, food, pets, plants, artwork, etc.
□ Do not block or obstruct the exhaust vent hose as it may severely affect performance, or cause failure of the air conditioner.
□ The air conditioner display shows the current room temperature.
□ When changing modes while the air conditioner is in operation, the compressor will stop for 3 to 5 minutes before restarting. If a
button is pressed during this time, the compressor will not restart for another 3 to 5 minutes.
□ In Cooling or Dry mode, the compressor and condenser fan will stop when the room temperature reaches the set temperature.
□ In Dry mode, the humidity level is automatically set, but is not able to be displayed.
1
Using the Control Panel
POWER ON OR OFF
COOL/FRAIS
□ The rst time the air conditioner is plugged in and turned on after your purchase, it will be set in Cool Mode.
DRY/SEC
TIMER
SLEEP
□ When the air conditioner is turned on at all other times, it will run according to the previous setting.
/MINUT.
/VEILLE
FAN/VENT.
POWER
MODE
/MARCHE
MODE
□ Press and release MODE until you see the symbol for the desired setting. Operating modes are Cool, Dry, Fan, or Heat.
MODE
□ Cool - Cools the room. Press FAN to select High or Low speeds. Press the Plus or Minus button to adjust the
temperature.
□ Dry - Dries the room. The air conditioner automatically selects the temperature. The fan runs on Low speed only.
Dehumidi cation ranges between 2 to 3 pints per hour by model.
NOTE: Dry mode should not be used to cool the room.
□ Heat - Heats the room. Press FAN to select High, Mid or Low speeds. Press the Plus or Minus button to adjust the
temperature.
NOTE: Heating is NOT available for cooling only models.
/MINUT.
/VEILLE
HIGH
/ÉLEVÉ
FAN
LOW
/VENT.
/FAIBLE
HIGH
/ÉLEVÉ
FAN
LOW
/VENT.
/FAIBLE
15
IMPORTANT: Keep upright at least 2
hours before use to prevent damaging the
compressor.
NOTE: In the event of a power failure, your
air conditioner will operate at the previous
settings when the power is restored.
NOTE: The symbols may be
different from these models,
but the functions are similar.

Publicidad

loading