NODOR NorCook IH N6404 BK Manual De Instrucciones página 26

your finger on the slider (2) in the direction shown by the light sequence (from right to left) and at the same
speed. You can now use the hob as usual.
Npause: Cooking pause
This function "freezes" the hob for up to 10 minutes. It is particularly useful if you cannot tend to your coo-
king for a short period of time. All cookware will stop receiving power and all timers and alarms are stopped,
just for the duration of the pause.
To activate this function, press key (3) for at least 1 second. All of the keys will remain disabled except the
lock key (4) and the On/Off key (1).
To cancel this function, press key (3) for at least 1 second. The pause icon will flash. Then, press any other
key within 10 seconds, otherwise the hob will switch off. All cooking processes will be resumed at the same
point they were when the pause function was activated. The cookware will be reheated to the same power
level and the timers will be reactivated. Only the Nboost and Nfastup functions are cancelled after the pause.
Nlimit: Operating time limitation (F8)
This safety function turns the heat off if an unusually long period of time has passed since the control was last
used. This time (L) depends on the selected power level (P).
See values in the F8 chart, where:
P is the selected power level.
L is the maximum operating time, in hours.
Each new action on the control of the cookware restarts the countdown to this time limit.
Nkey: Protects from continuous key pressing
This safety function is intended to protect the hob from prolonged and unintentional key pressing. Pressing any
key for more than 10 seconds will activate the error message "Er03" on the display (10) and turn off the control.
When the key is no longer being pressed, this error message will disappear, and the control can be turned
on again.
Note: Liquid spilled on the control area will not always activate this function.
Ntime: Timer for cookware
This function allows you to automatically programme the end of the cooking time for a piece of cookware.
Each piece of cookware has its own stand-alone timer. Several timers for several pieces of cookware can be
running at once. You can select the time you require within a range of 1 to 1h 59 minutes. The remaining time
is shown on the display (7) that shows the lowest timer value.
To activate this function, the cookware must be in use (power > 0). Press the display (10) designated to the
piece of cookware. Timer value can be set in 1-minute steps with plus-key (9) or minus-key (8). In each case,
the value will automatically be set 5 seconds after the last time it was touched. For each piece of cookware
with an active timer, the symbol (11) lights up above the display (10).
When switching-over from one cooking zone (10) to another, the timer display (7) always shows the present
timer value of the respective cooking zone and the corresponding display (11) flashes. However, the pro-
grammed timers of other cooking zones remain active.
If the timer is set to 0, then it will be cancelled without interrupting the cooking process.
When the timer reaches its last 10 minutes, the remaining seconds are shown on the display (7).
When the timer ends, the related cooking process is stopped, the display (7) flashes 0.00 and an acoustic
signal is emitted. The end of the timer will be confirmed, and the acoustic signal can be stopped by pressing
any key, or after 2 minutes.
60819760.31.08.2020.indd 26 60819760.31.08.2020.indd 26 8/10/20 10:34 8/10/20 10:34