ProfiCare PC-BS 3085 A Manual De Instrucciones página 53

NOTE:
If you would like to simultaneously use the wall mount as
a charging station, there must be a power outlet nearby.
1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the
floor nozzle installed.
2. Measure the distance between the two oblong holes of
the bracket and drill two holes in the wall while maintain-
ing this distance.
3. Insert the dowels into the wall.
4. Use a screwdriver to screw the screws into the dowels
and make sure they protrude around 3 - 4 mm.
5. Use the screws to hang the bracket against the wall.
Charging the Rechargeable Battery
CAUTION:
Do not charge the rechargeable battery unsupervised.
1. Turn off the appliance.
2. Connect the power supply plug to one of the sockets
listed below.
- A connection socket (3) is located directly on the
appliance.
- If you have already mounted the wall bracket, use the
connection socket on the bottom of the wall bracket.
Hang the appliance in the wall bracket. Always attach
it to the top of the latch first. The connection must
audibly engage.
3. Connect the power adapter to a certified wall socket.
Charge the appliance for approx. 4,5 hours before first-
time use.
NOTE:
• The indicator lights show the state of charge of the
rechargeable battery. (25 %, 50 %, 75 %, 100 %)
• The appliance has electronic charge control, which
prevents overcharging.
• Charging is completed when all 4 indicator lights
are lit.
• Once the appliance is disconnected from the power
adapter, the indicator lights go out.
• It is normal for the appliance to heat up during
charging.
4. Disconnect the power adapter from the outlet once the
rechargeable battery has been charged completely.
NOTE:
Even when switched off, the rechargeable battery dis-
charges continuously. If the appliance is out of use for a
longer period of time, charge the rechargeable battery at
least once every 4 to 6 weeks.
PC-BS3085A_IM_new
Using the Appliance
You can use the appliance as a floor vacuum cleaner or as
a handheld and upright vacuum cleaner (basic appliance).
1. Disconnect the appliance from the power adapter.
2. To remove the appliance from the wall bracket, hold its
housing with one hand while using the other hand to
slide the latch on the wall bracket upward.
3. Turn on the appliance.
CAUTION:
• The suction opening must be free of blockages at all
times. Blockages will cause overheating and damage
to the motor.
• If the brush roller in the floor nozzle no longer rotates,
it may be blocked by a foreign object. In this case,
remove the blockage as described in chapter "Clean-
"Floor Nozzle". You may then continue the
ing"
operation.
NOTE:
• We recommend the higher power level for using the
appliance with the floor nozzle.
• During operation, depending on the charging capacity
of the rechargeable battery, 1 to 4 indicator are lit.
• We recommend recharging the battery once the indica-
tor lights show a remaining capacity of only 25 %.
• Once the rechargeable battery is almost out of
power, the last indicator light will start flashing for a
few seconds. To avoid a complete discharge of the
rechargeable battery, the electronics will switch off the
motor automatically. Recharge the battery.
End of Operation
1. Turn off the appliance.
2. If you have already installed the wall holder, hang up the
vacuum cleaner.
Maintenance
Emptying the Dust Container
1. Disconnect the appliance from the power adapter.
2. If necessary, remove the suction tube or the nozzle
attachment from the appliance.
3. Hold the appliance with the opening flap over a dustbin.
4. Empty the contents of the dust
container. Then press the latch
(17) on the dust container to
open the flap.
5. Close the flap again. The lock
on the dust container must
engage.
The Filter System
Your appliance features 2 filters. The common dust bag
system has been replaced by a transparent dust container.
53
07.07.21