Eaton TRIPP-LITE CSD32USB Manual Del Propietário página 7

6. Wall Mounting
For wall mounting, you will need:
• Level
• Appropriate tools for wall mounting
• Appropriate hardware for wall mounting (not included)
Warning: Do not attempt to mount the charging station to the wall with any
personal electronic devices inside.
There are 4 keyhole cutouts on the charging station cabinet's rear panel. Each keyhole
can accommodate an M5 or 3/16" bolt. The keyhole sets are centered 16" apart
horizontally and 12" vertically
To mount the charging station, first remove the bottom shelf inside the cabinet
a level and tape measure, measure to position your mounting area precisely. For the
position where the top keyholes will be located, secure appropriate fasteners (not
included) to the wall or supporting surface, then hang the charging station onto the
hardware . For an added measure of security, use appropriate fasteners and the
C
bottom keyhole slots to secure the charging station cabinet to the wall
Note: The charging station must be installed by a qualified technician. Use suitable mounting
means when installing to cinder block, concrete, drywall or wood studs. Warning: The supporting
surface must be able to safely support the combined load of the charging station, equipment
stored and all attached hardware and components. See Section 8. Specifications for more
information on your model's weight and dimensions.
.
A
. Using
B
A
.
D
B
7
TOP
16"
12"
BOTTOM
C
C
D
D