Filling The Rinse Aid Reservoir
1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. Power on the dishwasher by plugging in;
2. Within 60 seconds after step 1, press the Program button more than 5 seconds,
and then press the Delay Button to enter the set model, the rinse aid indication
blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits ,
the sets will change in the following sequence: D3->D4->D5->D1->D2->D3,
Dispenser drops more rinse aid in D5 level than in another, the manufactory setting
is D3.
4. Without operation in 5 seconds or press the power button to exit the set model,
the set success.
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
12