Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTRUCTIONS FOR USE
ATTENTION!
◊ To protect the motor, the product must always cool down for 5 minutes after 10
minutes of continuous use (regardless of speed). After that, it can be used again.
3.1 Operation
1.
Press the button (A) to tilt the head of the product upward. (fig. 1).
2.
Slide the splash cover onto the head of the housing until it is firmly in place (fig.
2).
3.
Insert the mixing bowl into the product. Turn the bowl clockwise until it clicks
into place (fig. 3).
4.
Select the desired accessory and attach it to the accessory attachment point. To
do this, place the small recess of the accessory in line with the attachment point,
push the accessory up and turn it counterclockwise until it clicks into place. (Fig.
4 and 5).
5.
Put the ingredients into the mixing bowl. Be careful not to exceed the maximum
limit of 1.5 kg (1000 g dry matter and 500 g liquid).
6.
Hold down the button (A) and tilt the head of the product downward. (Fig. 6).
7.
Make sure the speed knob (B) is set to "0".
8.
Plug in the power cord.
9.
Set the speed knob (B) to the desired speed depending on the accessory you
are using (see 3.2).
10. Turn the speed knob (B) back to "0" once you have finished mixing. Do not use
the product for more than 10 minutes at a time.
11. Unplug the product to turn it off.
12. Press the button (A) to tilt up the head of the product.
13. Remove the bowl and remove the mixture from the bowl with a spatula.
14. Remove the cover and the accessory. To do this, push the accessory upward and
turn it clockwise.
15. Clean the bowl and the accessory thoroughly (see Chapter 5).
24
Publicidad
