Section2
GeneralInformation
2.1 -- Unpacking
•
Remove all packaging material.
•
Remove separate accessory box.
•
Remove the generator from carton.
2.1.1 -- Accessories
Check all contents. If any parts are missing or damaged, locate an
authorized dealer at 1-888-436-3722.
Product Registration and Warranty Cards
1 - Owner's Manual
1 - Liter Oil SAE 10W-30
2 - Never-Flat Wheels
2 - Frame Feet
1 - Fuel Cylinder Retaining Strap
1 - Oil Funnel
1 - Hardware Bag (containing the following):
-- 2-Rubber Feet (A)
-- 4-M8 Bolt (Long) (E)
-- 2-5/8" Axle Pins (B)
- 2-M6 Bolts (Long) (F)
-- 2-Cotter Pins (Hairpin) (C)
- 4-Hex Flanged M8 Nuts (G)
-- 2-5/8" Flat Washers (D)
- 2-Hex Flanged M6 Nuts (H)
-- Spark Plug Service Tool
- 1- Cotter Pin (Strap)
2.2 -- Assembly
The generator requires some assembly prior to using it. If problems
arise when assembling the generator, please call the Generator Help-
line at 1-888-436-3722.
2.2.1 -- Assembling the Accessory Kit
The wheels are designed into the unit to greatly improve the portabil-
ity of the generator.
You will need the following tools to properly install the accessory kit.
•
Needle Nose Pliers
•
Ratchet and 8mm, 10mm, and 13mm sockets
•
12ram, 10ram, and 13ram box wrenches
NOTE:
The wheels are not intended for over-the-road use.
1.
Refer to Figure 2-1 and install the Wheels as follows:
-- Slide the Axle Pin through the Wheel, Wheel Bracket on the
frame and 5/8" Flat Washer.
-- Insert the Cotter Pin through the Axle Pin to lock into place.
.
Refer to Figure 2-2 and install the Frame Feet and Rubber Bum-
pers as shown.
-- Slide the Rubber Bumper [v16 Bolts through the Frame Foot,
Rubber Bumper. Then install the Locking Flange Nuts.
Tighten securely.
-- Slide the Hex Head Bolts through the holes in the Frame Rail.
-- Slide the Frame Foot onto the Hex Head Bolts then install the
Locking Flange Nuts. Tighten securely.
Figure 2-1: Wheel & Feet Assembly
G
E
H
Figure 2-2: Frame Feet and Rubber Bumpers
Figure 2-3: Fuel Cylinder Retaining Strap
5,500 Watt LP Series Portable Generator
5