How To Clean; Troubleshooting - SousVideTools iVide PLUS Manual Del Usuario

EN // USER GUIDE
H O W TO C L E A N
Preparation
iVide Plus Thermal Circulator can be cleaned with food grade vinegar (white vinegar, apple vinegar, etc.)
Why the need to clean?
Normal tap water contains minerals which when the water is heated to a certain temperature will create a
scale on the heater or surface of the machine. In this case, the scale will affect the performance of the machine.
It is recommended to clean the machine every 20 times or after 100 hours of use. You can clean the machine
according to your actual needs due to different water in different areas.

How to clean

1
Fill the container (up to the MAX line) with water. Add 5g vinegar into the water.
2
Turn on the iVide Plus Thermal Circulator, set the working temperature to 80°C (176°F) and the time to 3
hours (03:00). Click START/STOP. After 3 hours, the machine will beep and switch off .
*Quick cleaning procedure: Hold down the START/STOP and - buttons. The digital reading (B) will show
the set temperature 80°C, the digital reading (C) will show the set time 3:00. Release the button and
the digital reading (B) & (C) will flash 10 times. Click the START/STOP button to start the cleaning
operation.
3
Check if the machine is clean. If the machine is not clean then add more vinegar and start the process again.
If the machine is clean, please drain the vinegar from the machine, wash the machine with fresh water, dry
and store away.
T RO U B L E S H O OT I N G
Error code
E01
E02
LP
** During the use of the machine, if any other problems arise, please speak to a specialist. Do not attempt
unauthorised repairs as this may result in an accident.
10
Cause of issue
The water level is lower than the
lowest water level or higher than the
highest water level
1. Whether the heating pipe is normal;
2. Whether the internal wiring of the
machine is normal;
3. Is the temperature sensor normal?
The machine suddenly loses power
during normal cooking

Troubleshooting

Turn off the power. If the water level is too low,
add the right amount of water to the container;
if the water level is too high, remove the water
from the container.
Need to ask a professional for repair