Operating Instructions; Maintenance - SousVideTools iVide PLUS Manual Del Usuario

EN // USER GUIDE
O P E R AT I N G I N S T RU C T I O N S
1
Start by attaching the iVide Plus Thermal Circulator to the cooking vessel. Turn the knob counterclockwise,
form a gap between the main body and the knob, insert the machine into the cooking vessel and tighten the
knob clockwise to secure the machine.
2
Add water to the cooking vessel, ensuring the water level is between the minimum water level and the max
water level.
3 Connect the power to turn on and illuminate the digital display. The iVide Plus Thermal Circulator will enter
the power saving mode after 2 seconds. After this time, press the power button to put the machine into ON
mode.
4
Click °C/°F to select the temperature display unit. The default is °C. Your selected temperature unit will be
remembered for next time you use the machine.
5 Click TEMP /TIME to select the temperature or time and set the target value with the + and - keys.
6
After the setting is complete, click START/STOP to start the machine. After the temperature in the cooking
vessel reaches the required temperature, the time digital reading (C) starts counting down - now add your
vacuum packed food for constant temperature cooking.
7 After the cooking is finished, the iVide Plus Thermal Circulator will beep. Click START/ STOP to turn off.
Note: If there is no operation, the machine will emit a continuous beep after 20 seconds, while the water
temperature will remain at the preset temperature.
8 Take your vacuum packed food out. The food is now ready for the next process.
9
After using the iVide Plus Thermal Circulator, turn off and store in a safe place.
DON'T FORGET: Before Sous Vide cooking, the food must be vacuum packed. The water level (after the food
is put in) should be higher than the MIN, but lower than the MAX marked on the machine. To avoid damaging
the machine, drain the water after use and clean the water bath.
M A I N T E N A N C E
To avoid burning, please make sure that the iVide Plus Thermal Circulator is turned off and cooled down to
room temperature before cleaning.
1 Place the iVide Plus Thermal Circulator vertically after cleaning, do not place it horizontally or upside down.
2
During cleaning, do not damage the components inside the machine. Once the components are damaged,
please ask a specialist to check and repair. Do not attempt unauthorised repairs as this may result in an
accident.
3 Empty the old water after each use. Refill with fresh water when you next use the iVide Plus Thermal
Circulator. If the water is reused, mineral substance may damage the components.
4
Remove the back cover of the iVide Plus Thermal Circulator to clean the heat tube and probe if the
discharge capacity reduces or the components have collected dirt. It is recommended to clean the iVide
Plus Thermal Circulator every 20 times or after 100 hours of use.
5 Do not put a hot iVide Plus Thermal Circulator in to cool water as this may cause damage. The iVide Plus
Thermal Circulator should be cooled down to room temperature and put into cold water to use.
9