Publicidad
Idiomas disponibles
Idiomas disponibles
8. Setting up power supply
Base device:
1. Insert the DC connector into the connection
socket (29) of the base station.
2. Insert the mains plug into the power outlet.
3. The device is energized directly.
4. Wait until the indoor temperature is displayed
on the base station.
NOTICE! For permanent operation, mains power
supply is recommended. Alternatively a power
supply with batteries is also possible, to keep the
time setting in case of power failure (permanent
backlight not active).
Proceed as follows:
5. Remove the battery compartment cover.
6. Insert the batteries into the battery compartment.
Ensure that the battery polarity (+/-) is correct.
7. Replace the battery compartment cover.
8. Wait until the indoor temperature is displayed
on the base station.
22
NOTICE! After 7 seconds, the display switches to
power-saving mode in battery mode. When using
battery power, press the SNOOZE/LIGHT button to
activate the display for about 7 seconds.
NOTICE! When switching from mains power
supply to battery power supply or vice versa, the
power supply is being disabled for a short mo-
ment for technical reasons. Exception: permanent
battery operation.
Remote sensor:
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compart-
ment. Ensure that the battery polarity (+/-) is
correct.
3. Set the channel selector switch to the desired
channel.
NOTICE! This weather station can be operated
with one or more remote sensors. Each remote
sensor being connected must be operated on a
Publicidad
