Publicidad
Idiomas disponibles
Idiomas disponibles
10
Additional information
TV system setting
The default setting of this system is AUTO, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO. If you find picture distortion with
some discs, set the TV system to match your
country or region's system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (AUTO, PAL and NTSC).
1
Switch the unit into standby, then press
SHIFT+SETUP.
Use / to choose TV SYS then press
2
ENTER.
The TV system changes as follows:
• AUTO NTSC
• NTSC PAL
• PAL AUTO
The system automatically switches on and
you'll see the new TV system setting in the
display after seeing WELCOME.
Media Type
DVD/Super VCD/
Video CD/DivX
video/WMV
CD/MP3/WMA/
MPEG-4 AAC/
JPEG/no disc
Note
1 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without color.
If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV has a
V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at the
top and bottom of the screen.
2 You have to switch the player into standby (press STANDBY/ON) before each change.
42
En
1
2
Player setting
Format NTSC
PAL
AUTO
NTSC
NTSC
PAL
NTSC
PAL
NTSC
PAL
PAL
—
NTSC
PAL
NTSC or
PAL
Frequency step setting
If you find that you can't tune into stations
successfully, the frequency step may not be
suitable for your country/region.
1
Switch the unit into standby, then press
SHIFT+SETUP.
Use / to choose AM 9K/10K then
2
press ENTER.
Use / to select AM 9K or AM 10K then
3
press ENTER.
Switching off the demo
Follow the steps below to switch the automatic
demo feature off (this starts when you plug in
for the first time):
1
With the unit in standby, press
SHIFT+SETUP.
Use / to choose DEMO then press
2
ENTER.
Use / to select DEMO OFF and press
3
ENTER.
Dimming the Display
You can adjust the brightness of the text in the
front panel display.
Press SHIFT+SETUP and use / to
1
choose DIMMER then press ENTER.
This is shown in the front panel display.
Use / to select LIGHT or DARK then
2
press ENTER.
Publicidad
