Husqvarna LF 50 Manual Del Usuario página 10

3. Set the choke control in the correct position. Refer
Product overview LF 50 on page 2 or Product
to
overview LFV 60 on page 3 for information about
where the choke control is on your product.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
4. Set the engine ON/OFF switch to "ON". Refer to
Product overview LF 50 on page 2 or Product
overview LFV 60 on page 3 for information about
where the ON/OFF switch is on your product.
10
5. Pull the starter rope handle slowly until you feel
resistance. Refer to
page 2 or Product overview LFV 60 on page 3 for
information about where the starter rope is on your
product.
6. Release the starter rope handle to let the starter
rope go back.
7. Pull the starter rope handle until the engine starts.
8. Open the choke control gradually until it is fully open.
9. Let the engine operate at idle speed for 2–3 minutes.
Product overview LF 50 on
1107 - 008 - 02.05.2024