Descargar Imprimir esta página

Husqvarna LF 50 Manual Del Usuario página 16

Ocultar thumbs Ver también para LF 50:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
chains or other lifting equipment with rough
edges that can cause damage to the lifting
eye.
WARNING:
product. Make sure that the vibration
damping units are correctly installed and not
damaged.
1. Set the product in transport position. Refer to
the LF 50 in transport position on page 12 .
2. Attach the lifting equipment to the lifting eye (A).
a) LF 50:
b) LFV 60:
A
16
Do not use metal hooks,
Do not lift a damaged
To set
A
B
B
To safety the product to a transportation
vehicle with tie-down straps
1. Put the handle in transport position. Refer to
the LF 50 in transport position on page 12 .
2. Put 2 straps around the bottom plate.
a) Put 1 strap around the front of the bottom plate
and attach the strap to the vehicle.
b) Put 1 strap around the rear of the bottom plate
and attach the strap to the vehicle.
LF 50:
LFV 60:
Storage
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
Clean the product before storage. Remove oil and
dust from the rubber parts.
Clean the air filter before storage.
Carefully pull the starter rope handle until there
is a small resistance. This closes the valves and
makes sure that moisture cannot go into the engine
cylinder.
To set
1107 - 008 - 02.05.2024

Publicidad

loading

Este manual también es adecuado para:

Lfv 60970 71 93-01