Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 37 Monday, February 26, 2024 2:45 PM
A:
Proper airflow is critical to the efficient operation of clothes dryers. A lint filter which is full of lint or
clogged with fabric softener sheet residue can reduce the airflow to the point that the time required
to dry clothing will be greatly increased.
Q:
Why does my dryer start by itself every few minutes?
A:
This is how the Fresh Care feature works. The dryer runs briefly every few minutes for up to 2 hours
after the cycle finishes. This feature is designed to help prevent wrinkles from setting in when the
dryer is not unloaded immediately after the cycle is finished.
Q:
How can I improve drying performance?
A:
For best results, use a dedicated cycle suitable for the load. For example, use the Towels cycle for
towels and the Jeans cycle for jeans. If you select a dedicated cycle and set the dry option, you will get
better results. If you want to dry it more, choose the time-drying of the Dry Only cycle.
Error Messages
Problem
Door open
The door is opened.
• Open and close the door again. If the message keeps appearing, unplug the power cord
Door unlocked
The door is not secured.
• Check for objects around the door and door seal. If the message keeps appearing, unplug
Water supply
Water supply faucets are not fully open.
• Make sure that the water faucets are fully open.
Water inlet hoses are kinked, pinched, or crushed.
• Make sure that the hoses are not kinked, pinched or crushed behind or under the washer.
Water inlet filters are clogged.
• Clean the inlet filters. See MAINTENANCE.
Water supply pressure to faucet or house is too low.
• Check another faucet in the house to make sure that household water pressure is
• Disconnect the water inlet hoses from the washer and run a few gallons of water through
• If flow is too low, contact a plumber to have the water supply lines repaired.
Water supply connected with leak-limiting hoses.
• The use of hoses designed to limit leaks is not recommended. Leak limiting hoses can trip
Drainage
Drain hose is kinked, pinched, or clogged.
• Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
• Move the end of the drain hose so that it is lower than 96 inches (2.4 m). For best
Unbalance
The load is too small.
• Add additional items to allow the washer to balance the load.
and call for service.
the power cord and call for service.
Be careful when moving the washer during cleaning or maintenance.
adequate and flow is not restricted.
the hoses to flush out any dirt.
falsely and prevent the washer from filling.
the washer.
performance, the end of the drain hose should be no higher than 66 inches (168 cm).
TROUBLESHOOTING
Possible Cause & Solution
37
Publicidad
