Gladiator Flex Cabinet System I Instrucciones De Ensamblaje página 12

INSTALL CABINET TO GLADIATOR
Install the 30" Tall Cabinet
NOTE: Flex Brackets are sold individually and Gladiator
GearTrack channels are sold separately.
®
1. Install the brackets to the tall cabinet.
X 3
P6
F3
P6
Attach the top bracket to the tall cabinet's back top with four
■
M6 round head square neck bolts (F5) and four M6 flange
nuts (F3).
Attach the center and bottom brackets to the tall cabinet's
■
back respectively with two M6 round head square neck bolts
(F5) and two M6 flange nuts (F3).
12
CHANNEL
®
X 8 X 8
F5 F3
Three brackets
required as
shown
F5
Orientation of the wall bracket
during assembly
GEARTRACK
®
2. Hang the tall cabinet onto the
GearTrack channels.
®
The GearTrack channels should be installed
®
with the spacing as shown.
Make sure all three brackets are fully engaged in the slots as
■
shown.
NOTE: . For installation of the Gladiator
please refer to the manual instructions included with the
Gladiator GearTrack channels.
® ®
®
30"
30"
(76.2 cm)
30"
30"
(76.2 cm)
GearTrack channels,
® ®