Gladiator Flex Cabinet System I Instrucciones De Ensamblaje página 6

2. Install the Grommets for Cord
Management (Optional)
X 1 per Cabinet
P5
1
P5
3
Use the short side of the hex wrench to punch out the knock-
■
outs of your desired cord access holes.
Then install the grommets into those holes.
■
6
ASSEMBLY INSTRUCTIONS
2
4
After Installation
3. Install the Shelves
Insert shelf brackets into the slots at the desired heights and
■
place the shelves over the shelf brackets.
Make sure all four shelf brackets are installed at the same
■
height.
3a. Install the shelf in the 2-door base
cabinet.
X 1
P13
P3
Slots on the inner
front side of side
panel
P13
Shelf locked by
shelf bracket after
installation
3b. Install the shelf in the wall cabinet.
X 1
P12
X 4
P3
P3
P12
X 4
P3
Slots on the
inner back
side of side
panel