Descargar Imprimir esta página

Aiwa NSX-A767 Manual De Instrucciones página 18

Sistemas estéreo con reproductor de discos compactos

Publicidad

Idiomas disponibles

Idiomas disponibles

AOPEN/CLOSE~
CD EDI
Press CD, then press A OPEN/CLOSE
to open the
disc compartment.
Load disc(s) with the label side
up.
To nlav one or two discs, place the discs on tray 1 and 2.
To plav three discs, press DISC CHANGE to rotate the trays
after placing two discs. Place the third disc on tray 3,
Close the disc compartment by pressing 4 OPEN/CLOSE.
Tray number of the
disc to be played
Total playing time
Total number of tracks
Load discs,
To ~lav all discs in the disc compartment,
press 4b.
Play begins with the disc on tray 1.
Number of track being played
Elapsed playing time
To play one disc only, press DISC DIRECT PLAY 1-3.
The selected disc is played once.
To stop play, press
,
To pause play, press II, To resume play, press again.
To search for a particular
point during playback,
keep ~
or >
pressed and release it at the desired point.
To skip to the beginning
of a track during
playback,
press
+
or *
repeatedly or turn MULTI JOG.
To remove discs, press = OPEN/CLOSE.
To start play when the power is off (Direct Play Function)
Press CD. The power is turned on and play of the loaded disc(s)
begins.
When 4 OPEN/CLOSE is pressed, the power is also turned on
and the disc compartment is opened.
To check the remaining
time
During play, press CD EDIT/CHECK.
The amount of time
remaining until all tracks finish playing is displayed. To restore
the playing time display, repeat the above.
When using the remote control, press CD EDIT/CHECK while
pressing SHIFT.
Selecting a track with the remote control
1 Press DISC DIRECT PLAY 1-3 to select a disc.
2 Press numbered buttons O-9 and +1 O to select a track.
Example:
To select the 25th track, press +1 O, +1 O and 5.
To select the 10th track, press +1 O and O.
The selected track starts to play and continues to the end of
that disc.
Replacing
discs during play
While one disc is playing, the other discs can be replaced without
interrupting
play.
1
Press DISC CHANGE.
2 Remove the discs and replace with other discs.
3 Press A OPEN/CLOSE to close the disc compartment.
When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the tray.
Do not place more than one compact disc on one disc tray.
Do not tilt the unit with discs loaded.
Doing so may cause
malfunctions.
Do not use irregular
shape CDs (example:
heart-shaped,
octagonal ones). It may result in malfunctions.
18
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

Cx-na767Sx-na772Sx-r275