Preparing to install the refrigerator.
Read these instructionscompletely and carefully.
Water Supply to the Icemaker (on some
If tim refiigerator
has an icemaker, it _411 have to be
connected
to acoM water line.
A water supply kit (containing copper robing,
shutoffvalve,
fittings and instructions)
is available
at extra cost fi'om your dealer or fi'oln Parks and
Accessories, 800-626-2002.
RefrigeratorLocation
Do not install tim refrigerator where tim
temperature
will go below 60°F. (16°C.)
because it will not mn often enough to lnainmin
proper telnperatures.
Install it on a floor strong enough to support it
fitly loaded.
Clearances
Allow the fbllowing clearances far ease of
installation, proper air circulation and
plumbing and electrical connections:
Sides 5/8" (15 mm)
Top
1" (25 ram)
If built-in, allow 7/8" (22ram)for hinge covers,
If tim refrigerator is against a wall on either side,
allow the following door clearances:
22'- 25' models
3/4" (19 mm)
27' models
1%" (38 mm)
Back 1" (25 mm)
Rollers
Themilershave3 purposes:
[--_Rollers a({just so the door closes easily when
opened about halfivay. [Raise tt_e from about
5/8" (15 mm) from the
floor.]
To assure that the doors will close automatically
from a halfi_ay open position, there is a built-in tilt
from the front to the back of tim cabinet. Side-b?_
side refrigerators
also have specially designed door
hinges that lifkboth doors slightly when opened,
allowing the force ofgravib_ to help close them
securely.
[_Rollers
a@lst so the refrigerator is firmly
positioned on the floor and does not wobble.
[_Rollers
allow you to move tt_e refrigerator
away
from tt_e wall for cleaning.
To adjust the milers, remove
the base _'ille by pulling
it out at the bottom.
Turn the roller a(Ousting screws clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use
an adjustable x_Tench (3/8" hex head bolt) or pliers.
Toreplace base grille, alia1 prongs on back of grille
with clamps in cabinet and push forward until _'ille
snaps into place.
17