Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
6.
Place the blower
unit back into the opening.
End A
End B
CAUTION:
Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower
unit exhaust
openings
should
match
exhaust
openings
on rear of microwave
oven.
7, Secure
the blower unit to the microwave
with the
screw.
Blower-Plate
f
_
From the Mounting
Back of
Microwave
Plate screw
8, Attach the exhaust
adaptor
to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Adaptor
Back of
i_
icrowave
_
Guide
Guide
From
Blower
motor screw
(after
attached
the exhaust
adaptor)
Push in securely
until it is in the lower locking tabs.
Take care to assure that the damper
hinge is installed
so that it is at the top and that the damper
swings
freely.
C5. MOUNT THE MICROWAVE
OVEN
FOR EASIER
INSTALLATION
AND PERSONAL
SAFETY,
WE RECOMMEND
THAT TWO PEOPLE
INSTALL
THIS MICROWAVE
OVEN.
IMPORTANT:
Do not grip or use handle
during
installation.
NOTE:
If your cabinet
is metal, use the nylon
grommet
around the power cord hole to prevent
cutting
of the cord.
NOTE:
We recommend
using filler blocks if the
cabinet front hangs below the cabinet
bottom shelf.
IMPORTANT:
If filler
blocks
are not used, case
damage
may occur from
over tightening
screws.
NOTE:
When mounting
the microwave
oven, thread
power cord through
hole in bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch cord
or lift oven by pulling cord.
1, Lift microwave,
tilt it
forward,
and hook slots
at back bottom edge
onto four lower tabs of
mounting
plate.
oven
up against
cabinet
bottom
3, Insert a self-aligning
screw through
top center
cabinet hole. Temporarily
secure the oven by
turning the screw at least two full turns after the
threads
have engaged.
(It will be completely
tightened
later.) Be sure
to keep power
cord
tight.
Be careful
not to pinch
the cord,
especially
when
mounting
flush
to bottom
of
cabinet.
2O
Publicidad
