Elta SGS-2400 Manual De Instrucciones página 22

steam.
3. Put the iron on the steam station iron's thermal insulating cushion.
4. Connect the plug to wall outlet, one "D" sound of buzzer can be heard and the
temperature indicator starts to illuminate.
5. Turn temperature dial to your desired setting, which is depended on the fabric
of garment, refer to IRONING TIPS latter. The soleplate starts to be heated up
and the temperature indicator begins to flash.
6. When the temperature indicator changes from flashing to illuminating, it
means the selected temperature is reached and the steam is ready for ironing.
Note: During ironing, the temperature indicator goes on from time to time. This
indicates that the iron is heating up to the set temperature.
Note: The system may occasionally produce a pumping sound during steam
ironing. This is normal and tells you that water is pumped into the soleplate.
7. Press the steam trigger to release steam for ironing.
Caution: 1) Do not touch hot soleplate at any time before cooling down!
2) Never direct the steam at people!
3) The supply cord may become hot during a long ironing session.
4)The appliance may not release steam if appropriate soleplate temperature has
not achieved or correct temperature setting has not been selected. (there is no
steam released under temperature setting 1 and 2.)
5)The water tank may need to be refilled if the pump produces larger noise.
8. After ironing, you can put the iron the thermal insulating cushion. Remove the
plug from the wall socket. But the soleplate is still hot, never touch it with hand,
place it on the thermal insulating cushion until it cools down completely.
9. And you can hold the iron in vertical position and press the steam trigger to
iron hanging curtains and clothes (jackets, suits, coats).
NOTE: Do not continuously operate the appliance for 1 hour.
10. The iron has an anti-drip function. When the soleplate is in the low
temperature condition, no matter if press down the steam trigger or not, there
will be no steam produced to avoid water droplets coming out from the soleplate,
and the steam can be produced again when the soleplate being in the high
temperature condition.
NETTOYAGE ET ENTRETIEN
Avant le nettoyage, débranchez d'abord la prise de courant et laissez l'appareil
refroidir.
1. Essuyer les flocons et autres dépôts sur la semelle à l'aide d'un chiffon
humide ou d'un nettoyant non abrasif (liquide).
REMARQUE: N'utilisez pas de nettoyants chimiques, en acier, en bois ou