Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the message password protection
For security reasons, the device accepts commands only if their sender is a number
stored in the phonebook.
However, it is possible to send commands to the device even from users that are not
among those stored in the phonebook.
In this case, however, it is necessary to enter the correct password before the
command (it is 1234 by default). For example:
CRONO HEATING
is a command executed only if sent by a number stored in the phonebook
1234 CRONO HEATING
is a command executed even if sent by a number not stored in the phonebook
It is recommended to change the password to ensure greater protection.
To change the password use the command:
PASSWORD [new password]
[new password] is a 4-digit number
For example:
PASSWORD 2276: changes the protection password to 2276.
Command with telephone call (ring)
The numbers saved in the phonebook can change the operating mode of the device
simply by making a telephone ring.
After a ring the device behaves as follows:
• if it is in automatic mode it activates off operation
• if it is in manual mode, it activates off operation
• if it is in off mode it activates automatic or manual operation, depending on which
operation was active before switching off
The number of the phonebook that made the call will receive an informative text
message on the status of the chronothermostat.
- 58 -
OB327200 Chronothermostat User Manual
Publicidad
