Publicidad
Idiomas disponibles
Idiomas disponibles
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Put nailer carefully down in defined safe resting position
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Reload fasteners 1 from the rear. Then pull feeder 2 to the rear
behind the fasteners 1 and let it slide the forwards.
5
Adjusting drive-in depth
Mechanical adjustment of drive-in depth:
Turn adjustment knob 1 for deeper countersunk nails clockwise.
Turn anti-clockwise to lower the nails less deeply.
6
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
Date: 25.01.2023
------------------------------------------
Dr. Jörg Dalhöfer, CEO
D34/90-G641E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
Publicidad
