Publicidad
Idiomas disponibles
Idiomas disponibles
Waste electrical products
must not be disposed of with
household waste. Please
recycle where facilities
exist. Check with your local
authorities or retailer for
recycling advice.
Li-Ion battery This product
has been marked with a
symbol relating to 'separate
collection' for all battery
packs and battery pack.
It will then be recycled
or dismantled in order to
reduce the impact on the
environment. Battery packs
can be hazardous for the
environment and for human
health since they contain
hazardous substances.
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Wear protective gloves
Remove battery from the
socket before carrying out
any adjustment, servicing or
maintenance.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling and disassembling the Power
head attachment. (See Fig. A1, A2, A3)
1. Remove the protective cap from the end of the
attachment shaft.
2. To assemble, align the triangle icon on the button
with the arrow label on the attachment shaft.
3. Push the shafts together until you hear a "click".
The edge of the arrow label should be close to
the shaft connection housing.(Note: If the curved
edger working head cannot be fully installed into
the power head, rotate the blade a little until it is
possible to insert the shaft fully.)
4. Finish the assembly by tightening the knob
clockwise.
5. To disassemble, loosen the knob, turn counter
clockwise, then press the release button and
pull the shafts apart. Replace the protective cap
on the attachment shaft to ensure that dust and
debris do not get into the shaft.
A1
A2
2
A3
3
2
Adjust the cutting height (See Fig. B1, B2)
1. Turn off the power tool and remove the battery.
2. Loosen the wing nut. Push the wheel upwards to
increase the cut depth (a) or downward the wheel
to reduce the cut depth (a).
EN
3
1
1
7
Publicidad
