Publicidad
Idiomas disponibles
Idiomas disponibles
D3
2
1. Align hole in inner blade adapter with notch in
gear housing, and insert locking tool to prevent
from rotating.
2. Loosen the bolt.
3. Replace the blade and tighten the bolt to 15~20
Nm (11~15 ft-lb).
Lubricating the Gear Box (See Fig. E1, E2)
E1
E2
1. Remove the screw plug from the gear housing
and inject about 5g of grease into gear case
every time.
2. Tighten the screw.
1
1
2
NOTE: Lubricating the gear case through the
oil-hole after every 50 hours operation. For best
operation and longer lifetime, it is recommened to
lubricate the Lawn Edger gear case with dedicated
grease (SHELL Gadus S2 V220 1).
CLEANING
1. Switch off the edger and remove the battery.
2. Do not use aggressive detergents or solvents.
Clean the machine after use with a damp cloth
dipped in mild detergent.
3. Keep battery connection free of dirt and debris,
and clean with a soft and dry brush or cloth.
4. Do not spray water onto the motor and electrical
components.
5. Do not use pressure washer to clean your
machine.
STORAGE
1. Remove the battery pack from the edger before
storage.
2. Store the edger and the battery in a dry and
secure place that is inaccessible to children and
other unauthorized people.Remove the cutting
attachment if no use for a long time.
3. If the machine becomes wet in the rain during
operation, the machine and the battery should
be dried before storing or charging. Remove the
battery and reinsert it if the machine fails to turn
on.
TROUBLESHOOTING
The following table gives problems and actions that
you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and
remove the battery prior to any
troubleshooting.
EDGER
Problems
Possible
Causes
Battery
Low battery
indicator LED
voltage.
flashing
EN
Corrective
Action
Charge the
battery.
9
Publicidad
