Publicidad
Idiomas disponibles
Idiomas disponibles
STACkING kIT INSTALLATION
This stacking kit includes:
• T wo (2) side rails
• O ne (1) front rail
• F our (4) screws
Tools Needed for Installation:
• P hillips-head screwdriver
Make sure the surface of the washer is clean
1
and dry. Remove paper backing from the
tape on one of the stacking kit side brackets.
To ensure safe and secure installation, please
observe the following instructions.
wWARNING
• Incorrect installation can cause serious
accidents.
• The weight of the dryer and the height of
installation make this stacking procedure too
risky for one person. Two or more people are
required when installing the stacking kit.
There is a risk of serious back injury or other
injuries.
• Do not use the stacking kit with a gas dryer
in potentially unstable conditions such as a
mobile home. Failure to follow this warning can
result in serious injury.
• Place the washer on a solid, stable, level
floor capable of supporting the weight of
both appliances. Failure to follow this warning
can result in serious injury.
• If appliances are already installed,
disconnect them from all power, water, or
gas lines and from draining or venting
connections. Failure to do so can result in
electrical shock, fire, explosion, or death.
Fit the side bracket to the side of the washer
2
top as shown in the above illustration. Firmly
press the adhesive area of the bracket to the
washer surface. Secure the side bracket to
the washer with a screw on the back side of
the bracket. Repeat steps 1 and 2 to attach
the other side bracket.
39
Publicidad
