Publicidad
Idiomas disponibles
Idiomas disponibles
• Select a place with a strong, level floor.
• Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
• Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on
the evaporator, and your refrigerator.
• Before connecting your refrigerator to the power supply, check that the voltage stated on the
rating label of your appliance corresponds to the voltage in your home. A different voltage
could damage the appliance.
• The plug is the only way to disconnect the device from the power supply, make sure it is always
easily accessible. To disconnect power to the device, turn off the device and then unplug it.
• After installation, leave the fridge for 12 hours before turning it on. This way the refrigerant can
settle.
• Allow the appliance to run empty for 3 hours begore filling.
• You can level the appliance using the adjustable legs. The adjustable legs can be adjusted by
screwing them in or out of the appliance.
• The climate class indicates the minimum and maximum ambient temperature for the proper
operation of an appliance. You can find the climate class on the type plate on the inside or back
of the appliance.
• SN: Subnormal: ambient temperature between 10°C and 32°C
• N: Normal: ambient temperature between 16°C and 32°C
• ST: Subtropical: ambient temperature between 16°C and 38°C
• T: Tropical: ambient temperature between 16°C and 43°C
DOOR CONVERSION
If you need to hinge your door on the opposite side, it is recommended that you call your local
authorised service agent to make this conversion or ask a technician. Before you reverse the door,
you should ensure the appliance is unplugged and empty.
1. Remove the protective cap from the hinge. On the other side, remove the cover plate. Inside
the door, remove the rubber cover cap at the top.
2. Remove the 3 screws from the top hinge. Remove the top hinge. You can then lift the door
off the lower hinge. Place the door somewhere it is safe from becoming scratched. When you
change the door-opening direction, we recommend that you also rotate the rubber seal around
the door. This ensures the door seals perfectly when you replace it.
3. Tilt the appliance, unscrew the feet and remove the 3 screws in the bottom hinge. Now remove
the hinge.
4. Use the 3 screws to securely attached the hinge on the other side of the fridge. Screw the feet
back into their holes.
Lift
Lower
www.domo-elektro.be
43
Publicidad
