Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction on Battery Charging
- When tool efficiency becomes low, charge the battery.
- New batteries only reach maximum power after 5 charge
and discharge cycles. The first 5 charges should last
4–5 hours, that way, the battery will reach its maximum
performance level and charge capacity.
- In order to charge the battery, connect the charger
plug to the power mains, then fit the battery properly
into the charger. Since the charger model is dual voltage
(100–240V a.c.), it can be used in both available voltages.
Charger LED functions:
Green
Phase:
LED
Charging
Charged
Instructions for Drill/Driver
Operation
1. Battery installation and removal:
- Charge the battery;
- Fit the battery on the back of the tool by pushing it until
it fits into the right position;
– You will hear a click when it is in the right position;
20
Led
Red
LED
Off
On
On
Off
Instruction Manual
– In order to remove the battery, press the side buttons
and pull it forward;
2. Fastening bits and accessories:
- Set the rotation direction switch to its central position,
avoiding involuntary start of the tool.
- Loosen the chuck by turning it counterclockwise.
42383/216 - 12 V Cordless Drill
Publicidad
