Publicidad
Idiomas disponibles
Idiomas disponibles
6. Battery charge level:
- This tool is equipped with battery level indicator LEDs.
- In order to check battery level, position the rotation
direction switch on the center position, and press it.
Battery level can be noticed based on the LEDs.
Charge level:
- High: green, yellow, and red.
- Medium: yellow and red.
- Low: red.
7. Tips for using drills/drivers:
- If the tool becomes too hot, operate it without any load
at maximum rotation for a few minutes to cool down the
motor and the equipment housing;
- Avoid working for a long time at low speeds;
- Always make sure that the work piece is firmly clamped,
avoiding any movement;
- When the work is done, let the tool run without any load
for a short period of time in order to loosen any dust and
dirt stuck to the bit and tool;
- For metal drilling, we recommend using high-speed
steel (HSS) bits with perfect sharpening.
- When you need to fasten long or high diameter screws,
we recommend prior drilling with the thread core
diameter up to approximately 2/3 of the screw length.
22
Instruction Manual
- When you need to make a high diameter hole, we
recommend starting to drill with a small diameter bit,
then widen the hole with the proper diameter bit. This
avoids overloading the tool's motor.
NOTE: the pictures are for illustrative purposes only,
always wear personal protective equipment (PPE)
while working with electric tools, such as leather
gloves, faces masks for protection against dust and
soot, anti-slip safety shoes, hard hat, earplugs, and
safety goggles.
Technical Support and
Maintenance Service
a) Always unplug the power tool before inspecting or
cleaning it.
b) Never use water or chemical products to clean the
power tool. Clean with a dry cloth.
c) The air vents should be cleaned frequently so air is
not blocked from ventilating the motor. Failure to do
so will cause the motor to overheat, which will damage
the appliance.
d) Always inspect the power tool body, electric cord,
and plug for damage or cracks that may cause electric
shock.
e) Always keep your working area clean and well
ventilated to prevent dust and other particles from
getting in the appliance's fan system.
f) For further information about maintenance and
repair services for Tramontina power tools and
appliances,
access
tramontina.com.br/assistencia-
tecnica or email atendimento@tramontina.com
Serial Number
a) This appliance has a serial number printed on its
main label. Before operating the power tool, write the
serial number in the space provided on the cover of the
instruction manual. This will ensure that even if the
label gets damaged from use, you will have the number
available.
42383/216 - 12 V Cordless Drill
Publicidad
