Publicidad
Idiomas disponibles
Idiomas disponibles
The combi drill can be used both to bore holes and to
tighten/loosen screws. For this purpose, drills and bits are
used.
Never insert or change the drills and bits while the
appliance is running. Always switch off the combi drill
before doing this.
1. Set the forward/reverse button (5) to the middle position
to lock the "ON/OFF" switch (10);
2. Hold the combi drill by the handle with one hand and
unlock the quick-change chuck (1) clockwise until the
drill or bit can be inserted;
3. Insert the drills or bit into the quick-change chuck;
4. Hold the combi drill by the handle with one hand and
lock the quick-change until the drill or bit is properly
fastened in the chuck jaws.
When using screwdriving bits always use a magnetic bit
holder.
The combi drill can be used both to bore holes and to
tighten/loosen screws. For this purpose, drills and bits are
used.
When operating the combi drill, you must consider some
use procedures:
▪ When working on small or loose workpieces, use
clamping devices to fix parts securely and stably;
▪ Do not apply excessive pressure on the drill against the
workpiece/object. If the speed drops abruptly, reduce
the pressure applied to the combi drill immediately;
▪ When the bit or drill gets jammed, switch off the power
tool immediately. Avoid the high reaction torques that
cause kickback;
▪ Never put the tool down before the rotating accessory
has completely stopped.
▪ Switch off the combi drill immediately if any of the
following problems occur:
- Grease leakage through the ventilation slots;
- Damage to the combi drill housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or burning smell.
1. Press the "ON/OFF" switch (10) and touch the drill or the
bit against the surface or screw;
2. To increase and decrease the rotation speed, press the
"ON/OFF" switch fully or smoothly respectively. The
maximum speed is reached with the switch pressed
down completely;
3. To switch off the impact drill, release the "ON/OFF"
switch.
While the combi drill is running, the LED light will
illuminate.
Do not change the direction of rotation while the combi drill
is running, it can cause serious damage to the appliance.
Always check the direction of rotation before starting to use
the combing drill.
1. Use the forward/reverse (5) to select the shaft direction
of rotation:
▪ With the forward/reverse button set to the left, the
shaft rotates clockwise;
▪ With the forward/reverse button set to the right, the
shaft rotates counterclockwise;
▪ If the forward/reverse button set in the middle
position, the ON/OFF switch is locked.
The torque must be adjusted according to the type of work
to be carried out and the size of the screws used.
1. To select the desired torque value, turn the torque clutch
(2) according to the scale.
For less hard surfaces and smaller screws use lower torque
positions. For harder surfaces and larger screws use higher
torque positions.
Publicidad
