Publicidad
Idiomas disponibles
Idiomas disponibles
Sleep mode
• If no operation in 1 minute, the dispenser will automatically go to sleep mode.
• When the dispenser is in sleep mode, only the safety lock indicator is on, all other indicators are o .
• Touch any button to end the sleep mode.
Boiling point calibration
• To prevent excess steam, the local boiling point should be checked and
adjusted; when the ltration is done and extracting water at 100°C for the
rst time, boiled water will ow out from the nozzle and the boiling point
calibration will be completed automatically. This procedure will last for
about 60 seconds. A container with a volume not less than 500ml should be
placed under the nozzle during this procedure.
Note: There might be steam ejection during the boiling point calibration,
please be aware of burn hazards.
Removeable drip tray
• If a small cup is used, the removable drip tray can be adjusted to a higher
position by pulling it out and putting it at the higher position directly.
One-key emptying
• Long press "
" 45°C button and "
dispenser will extract water until the ltered water jug and the inner pipes
are empty.
Note: In order to avoid dry-heating, after one-key emptying, please extract
some ambient water before extracting hot water.
" 300ml button for 3 seconds, the
09
3s
3s
Publicidad
