Publicidad
Idiomas disponibles
Idiomas disponibles
10. Trouble shooting
Error
Cannot extract
ambient water
Button is not pressed properly
The dispenser is dry-heating
Cannot extract
hot water
Filter cartridge is not installed
properly
Cannot lter
The water in the raw water
water
tank is at low water level
The raw water tank is not
installed properly
The quality of the raw water
Strange
does not meet the requirement
noise when
and the lter cartridge is
ltering
blocked earlier than expected
The removable drip tray is full
Water
leakage
The sealing valve at the bottom
of the raw water tank is blocked
Water oozes from the dispenser
The new dispenser hasn't
been cleaned
Odd taste of
The dispenser has not been used
the water
for a long time
Filter cartridge is not changed
as required
Causes
The product is not connected with
the power supply
The water in the ltered water
jug is at low level
The check valve on raw water
tank base is blocked or at
wrong position
Check if the dispenser is well connected with
power supply
Press the water extraction button again
Extract ambient water for several times,
and then extract hot water
Wait for a while till the water ltration
indicator stops ashing
Disconnect the dispenser from the power
supply. Open the machine top lid and take out
the lter cartridge, then install it properly
Take out the raw water tank and change
water
Check the raw water tank and install it
properly
Change the lter cartridge and check it again
Empty the removable drip tray
Put the check valve back to the original
position with a thimble, or contact customer
services to change it
Hold the sealing valve with a thimble or a
nger, remove the blockage
Empty the raw water tank and ltered water
jug, power o , then contact customer services
Follow the cleaning procedures for rst time
use
Follow the cleaning procedures for rst time
use
Change the lter cartridge
13
Solutions
Publicidad
