Stanley SCH201C2K Manual De Instrucciones página 22

22 • ENGLISH
SAFETY OF OTHERS
f This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
f Children should be supervised to ensure that they
do not play with the appliance.
RESIDUAL RISKS
Additional residual risks may arise when using the tool
which may not be included in the enclosed safety warnings.
These risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
f Injuries caused by touching any rotating/moving parts.
f Injuries caused when changing any parts, blades or
accessories.
f Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you take
regular breaks.
f Impairment of hearing.
f Health hazards caused by breathing dust developed
when using your tool (example: working with wood,
especially oak, beech and MDF.)
ADDITIONAL SAFETY INSTRUCTIONS
FOR BATTERIES AND CHARGERS
BATTERIES
f Never attempt to open for any reason.
f Do not expose the battery to water.
f Do not store in locations where the temperature may
exceed 40°C.
f Charge only at ambient temperatures between 10°C
and 40°C.
f Charge only using the charger provided with the tool.
f When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
f Do not attempt to charge damaged batteries.
CHARGERS
f Use your STANLEY charger only to charge the battery
in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
f Never attempt to charge non-rechargeable batteries.
f Have defective cords replaced immediately.
f Do not expose the charger to water.
f Do not open the charger.
f Do not probe the charger.
STORAGE RECOMMENDATIONS
1. The best storage place is one that is cool and dry
away from direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger.
FEATURES (Fig. A)
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
This product uses the batteries and chargers listed below:
20V MAX Lithium-Ion Batteries:
SB20C (1.3Ah), SB20D (2.0Ah).
20V MAX Lithium-Ion Chargers:
SC201 (1A), SC202 (2A).
CHARGING PROCEDURE
STANLEY chargers are designed to charge STANLEY
battery packs.
Charging time:
SB20C (1,3Ah) + SC201 (1A) = Charge time 75 min.
SB20C (1,3Ah) + SC202 (2A) = Charge time 45 min.
SB20D (2,0Ah) + SC202 (2A) = Charge time 60 min.
1. Plug the charger into an appropriate outlet before
inserting the battery pack.
2. Insert the battery pack into the charger.
3. The led will flash indicating that the battery
is being charged.
4. The completion of charge is indicated by the
led remaining on continuously. The pack is
fully charged and may be used at this time
or left on the charger.
Recharge discharged batteries as soon as possible
after use or battery life may be greatly diminished. for
longest battery life, do not discharge batteries fully.
it is recommended that the batteries be recharged after
each use.
CHARGER DIAGNOSTICS
This charger is designed to detect certain problems that
can arise with the battery packs or the power source.
Problems are indicated by one LED flashing in different
patterns.