Beta 1928P Instrucciones página 11

INSTRUCTIONS FOR USE
TECHNICAL DATA
SOCKET DRIVE
BOLT CAPACITY (8.8)
BOLT CAPACITY (12.9)
FREE SPEED
MAXIMUM TORQUE
AIR INLET
MINIMUM INTERNAL HOSE SIZE
MAXIMUM PRESSURE
MAXIMUM AIR CONSUMPTION
WEIGHT
LENGTH
HAMMER DEVICE TYPE
NOISE (ISO 15744)
SOUND POWER LEVEL
SOUND PRESSURE LEVEL
VIBRATIONS (ISO 28927)
VIBRATION LEVEL
UNCERTAINTY
LEGEND
a: Air inlet 3/8'' GAS
b: Impact wrench start button
c: Hammer face greasing
d: Rotation reverse and torque selection lever
e: Selected torque
f: Oil lubrication
Air supply connection
For the correct use of the pneumatic wrench, always observe the maximum pressure indicated in the technical data table, as
measured at the tool inlet. Feed the pneumatic tool with clean, condensate-free air (picture 2-a). Excessively high pressure or
humidity in supply air results in shorter life for the mechanical parts and may damage the tool.
USE
Start / Stop
To start the pneumatic tool, press the start button (picture 3-b), and keep it pressed during the job to be performed. Releasing
the button will cause the pneumatic tool to stop quickly.
Check the position of the reverse lever (picture 4-d) before operating the pneumatic tool, so as to know the direction of rotation.
Setting direction of rotation
The pneumatic tool can rotate both clockwise and anticlockwise. Select the direction of rotation using the reverse button
(picture 4-e):
Clockwise – seen from the operator's side
Anticlockwise - seen from the operator's side
3/4"
M30 - 46 mm
M27 - 41 mm
5000 Giri/min
2100 Nm
3/8" GAS
10 mm
6.2 Bar
221 l/min
3,7Kg
236 mm
Double hammer
L = 107.2 dB
wA
L = 96.2dB
pA
7.6 m/s
2
K= 1.25 m/s
2
EN
11