Beta 1928P Instrucciones página 12

INSTRUCTIONS FOR USE
Use the reverse lever to select the direction of rotation and couple:
selection • minimum screwing torque (approximately 1/3 of max. screwing torque)
selection •• medium screwing torque (approximately 2/3 of max. screwing torque)
selection ••• maximum screwing torque
selection • maximum unscrewing torque
Fit the required impact socket onto the male drive, and make sure that it is inserted correctly.
Always disconnect the air supply before fitting in tools or making adjustments; this precaution will prevent the
pneumatic tool from being accidentally started.
LUBRICATION/GREASING
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil
microfog mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply
hole (picture 5-f).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force
in your country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for
professional use or a 24-month warranty for nonprofessional use. We will repair any breakdowns caused by material
or manufacturing defects by fixing the defective pieces or replacing them at our discretion. Should assistance be required
once or several times during the warranty period, the expiry date of this warranty will remain unchanged. This warranty
will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will
no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
EU DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of
Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-6
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALIA
12
EN
Date 01/03/2023